Electrolux EHL8840FOG User Manual page 14

14 www.electrolux.com
The heat setting changes
between two levels.
The sensor fields become
hot.
There is no signal when
you touch the panel sen-
sor fields.
The backlight is on, but
the contrast of the display
is bad.
II and text come on.
comes on.
? comes on.
E and a number come
on.
Problem Possible cause
The Power management
is activated.
The cookware is too large
or you put it too near to
the controls.
The signals are deactiva-
ted.
The hot cookware is on
the display.
The Automatic Switch Off
operates.
The Child Safety Device
or the Lock function op-
erates.
No cookware is on the
cooking zone.
The cookware is incor-
rect.
The diameter of the bot-
tom of the cookware is
too small for the cooking
zone.
The cookware does not
cover the cross / square.
There is an error in the
appliance.
Remedy
Refer to "Power manage-
ment".
Put large cookware on
the rear cooking zones if
necessary.
Activate the signals (refer
to "Deactivation and acti-
vation of the sounds").
Remove the object and
let the appliance become
sufficiently cool. If the
contrast is not clear,
speak to the service cen-
tre.
Deactivate the appliance
and activate it again.
Refer to the chapter "Dai-
ly Use".
Put cookware on the
cooking zone.
Use the correct cook-
ware.
Use cookware with cor-
rect dimensions.
Cover the cross / square
fully.
Disconnect the appliance
from the electrical supply
for some time. Discon-
nect the fuse from the
electrical system of the
house. Connect it again.
If E comes on again,
speak to the service cen-
tre.