GE Side-by-Side Built-In Refrigerators Owner's Manual page 10

How it Works
Dispenser
with
The electronic controls on the dispenser are
glass-touch
truly interactive. The control panel is equipped
with a proximity sensor that causes the panel to
controls
light up as you approach the dispenser (approx.
2 inches). To make a selection, simply touch
the graphic for the feature you want, and the
halo for that feature will light up. When you walk
away from the refrigerator, the lighted graphics
switch off automatically.
How to Use
To dispense water or ice: select WATER
ICE
gently against the top of the dispenser cradle.
The spill shelf is not self-draining. To reduce
water spotting, the shelf and its grille should be
cleaned regularly.
If no water is dispensed when the refrigerator
is first installed, there may be air in the water
line system. Press the dispenser cradle for at
least two minutes to remove trapped air from
the water line and to fill the water system.
To flush out impurities in the water line,
throw away the first gallon of water.
CAUTION:
or any other objects into the ice crusher
discharge opening.
Locking the Dispenser:
Touch CONTROL LOCK for
3 seconds to lock the dispenser
and control pad. To unlock, touch
it again for 3 seconds.
10
or CRUSHED ICE . Then press the glass
Never put fingers
Ice & Water Dispenser
Built-In Refrigerators
Dispenser Light:
, CUBED
This feature turns the night light
on and off. The light also comes
on when the dispenser cradle is
pressed. If this light burns out, it
should be replaced with a 6 watt
12V maximum bulb. The bulb is available
through GE Parts and Accessories, 800.626.2002.
Order part number WR02X10675.
Door Alarm:
To turn the Door Alarm feature on,
touch DOOR ALARM once. To turn
it off, press it again.
When the DOOR ALARM
is active, the alarm will flash and beep if you
keep the door open for more than 2 minutes.
(on some models)
Spill Shelf