Step 7, Secure Refrigerator To Cabinetry; Step 8, Adjust Door Swing; Step 9 Install Grille Panel - GE Side by Side Refrigerators Installation Instructions Manual

STEP 7 SECURE REFRIGERATOR
TO CABINETRY
Whenever possible, perform this step for anti-tip
security, or when anti-tip brackets cannot be used.
The refrigerator must be secured to prevent tipping.
• Raise the grille panel to access case trim.
• Drill hole in trim and drive screw through the trim
into adjacent cabinet.
• Follow the same procedure on the opposite side.
Raise Grille Panel
to Stop Position
Drive Screws
Through Case Trim Into
Adjacent Cabinets
STEP 8 ADJUST DOOR SWING
NOTE: This refrigerator has a 2-position door stop.
When space does not allow the door to swing open
fully to 130°, you may change the door swing to a 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
90˚
Interior
Hinge
• Open the door to view the bottom hinge. Note the
door stop pin locations. The pin is factory installed
in the 130° position.
• Close the door. From below, use pliers to unscrew
the door stop and reinstall into the 90° position.
Installation Instructions
130˚
Door

STEP 9 INSTALL GRILLE PANEL

To insert framed or overlay panel into the grille:
• Raise the grille panel to stop position.
Loosen
Side
Trim
Screw
Spring to Accommodate
• Loosen screws on side trim behind frame. Remove
bottom trim.
CAUTION:
slippery. Grip metal panel firmly, so the panel does
not slip out of the frame and cause personal injury
or damage to the frame.
PRUDENCE :
peut bêtre glissant. Tenir fermement le panneau en
métal, de manière à ce que le panneau ne glisse pas
en dehors du cadre en provoquant des blessures
corporelles ou des dommages au cadre.
• Slide panel over the metal backer panel and into
the trim.
• If necessary, tap with a wood block until panel slips
under the top trim piece.
• Reassemble bottom trim. Tighten screws.
• Adjust the hinge spring to accommodate the panel
weight, if necessary.
14
Raise
Grille
Panel
Adjust Nut Below
Panel Weight
Metal panel may be
Le panneau en métal
Loosen
Side
Trim
Screw