Name Display (Administrator) - NEC UNIVERGE DT310 User Manual

Name Display (Administrator)

Note:
Requires Display Phone
A name with up to 16 characters can be entered to
display the name on other Dterm telephones when
making a call.
Press Speaker key. Receive set tone.
Dial the Name Assignment access code and
receive special dial tone.
Using the keypad, depress the key with the desired
letter to display the first letter on the key. The
display will indicate the numerical designation.
Subsequent depressions will advance through the
letters on that key. The Dial Pad Key Table below
can be used as a guide to indicate the key and the
number of depressions required to display, letters,
spaces and periods.
DIAL PAD KEY
1 2 3 4
1 1 2 3 4
2 - A D G J
3 - B E H K
4 - C F I
5 -
5 6 7 8 9 0
5 6 7 8 9 0
M P T W
N Q U X
L O R V Y
S Z
When the desired letter is displayed, depression of
the Transfer key will change the letter to a lower
case letter (default is upper case). Depress the
Hold key to enter that letter and advance to the
next entry.
Repeat the previous two steps until the desired
name is displayed and entered.
Press Speaker key.
For example, to enter "Paul".
7 7
8 8
5 5
Note:
When adding/changing/deleting name display for
an extension that appears on a key of a 16LD phone
a reset of the 16 LD phone is required and can be
* #
accomplished by an unplug/plug-in of the phone.
For the 16LD phone using one of the line keys as
* #
speed dial will only display 8 characters; For a
* # name the first 7 characters plus * for names longer
than 8 characters and the * plus last 7 digits of a
* #
number longer than 8 digits.
* #
Example: name display programmed is ABCDEFGHI
* #
button will show ABCDEFG*. Number display
programmed is 123456789 button will show *3456789.
38
HOLD 2 2 TRF
8 TRF HOLD
5 5 TRF
HOLD
HOLD