Table of Contents
Advertisement
30 electrolux
Installation Instructions
Installed oven SMS width
55cm with exhaust air
When installing in combustible materi-
1
als, the NIN 2005, chapter 4.2.2 and the
fire protection guidelines and the direc-
tives of the Association for Cantonal Fire
Insurances must be observed at all
times.
1.
Pull the appliance drawer out as far as it
will go, lift and then remove.
2.
Push the oven flush with the niche.
Make sure that the cable does not catch
when pushing the oven in.
3.
Fix the oven on both sides using at least
2 screws (Detail A).
4.
The enclosed check valve F is screwed
in to the exhaust air hose. Mount the
check valve F with hose to the appliance
(bayonet connection).
Exhaust air temperature: max. 80°C.
A shortened element must be installed
3
above the oven.
The rear wall must be able to be re-
moved.
Air flow diagram
Planning and installation examples: See ex-
haust air examples for BO and DA Instr. no.
31
Electrical connection/power supply
The oven must be connected to the electric-
ity supply by a qualified electrician or a com-
petent person.
Use a H05VV-F type power cable or higher.
The appliance must be installed with a sock-
et supply line, otherwise the fixed home elec-
trical system must include an isolating device
with at least a 3mm-contact separation to
enable a simultaneous and all-pole cut off
from the mains, according to NIN 2000.
For connecting to appliance directly to the
mains, use a minimum cable length of
120cm.
Advertisement
Table of Contents
