Problem Solver - GE Monogram ZEK735 Use And Care Manual

PROBLEM
"F–AND A NUMBER
OR LETTER" FLASH
IN THE DISPLAY
CONTROL SIGNALS AFTER
ENTERING COOKING TIME
OR DELAY START TIME
DISPLAY GOES BLANK
DISPLAY FLASHES
UNABLE TO GET THE
DISPLAY TO SHOW "SF"
"PROBE" APPEARS IN
THE DISPLAY
"LOCK DOOR" FLASHES
"LOCKED DOOR" FLASHES
OVEN LIGHT DOES
NOT WORK
OVEN WILL NOT SET A
SELF-CLEAN CYCLE
OVEN NOT CLEAN
AFTER CLEAN CYCLE
DOOR WILL NOT
OPEN AFTER
SELF-CLEAN CYCLE
32
QUESTIONS?
USE THIS PROBLEM SOLVER
POSSIBLE CAUSE
• This is a function error code. Press CLEAR/OFF. Allow the oven to cool one
hour. Place the oven back into operation.
• Disconnect all power to the oven for 5 minutes and then reconnect power. If the
failure code repeats, call for service.
• This is reminding you to press BAKE and then enter a bake temperature.
• This is reminding you to enter a bake temperature after having pressed BAKE.
• The circuit breaker in your house has been tripped, or a fuse has been blown.
• Power failure. Reset the clock.
• BAKE and BROIL HI/LO must be pressed at the same time and held for
2 seconds.
• The probe is not inserted properly into the oven receptacle or food.
• This is reminding you to enter a probe temperature after plugging in the probe.
• Oven door not closed after self-clean cycle is selected.
• Door is still locked and you are trying to enter an oven cooking operation.
• The light bulb is loose or defective. Tighten or replace.
• The pad operating the oven light is broken. Call for service.
• Oven temperature is too high to set self-clean operation.
Allow the oven to cool to room temperature and reset the controls.
• The probe is plugged into the outlet in the oven. Remove the probe from the oven.
• Oven controls not set properly. See the Operating the Self-Cleaning
Oven section.
• Heavily soiled ovens require 4 to 5 hours of clean time.
• Heavy spillovers should be cleaned up before starting clean cycle.
• When the temperature has fallen below the locking temperature door can
be opened.