Electrolux EHG 6415 Operating Instructions Manual page 14

14 electrolux
IMPORTANT - To ensure a correct
operation, a savingof energy and the
long life of the appliance, the voltage
pressure of the appliance must
correspond to the recommended values.
The adjustable connection is fixed to the
comprehensive ramp by means of a
threaded nut G 1/2". Interpose the
sealing between the components as
shown in Fig. 5. Screw the parts without
forcing, adjust the connection in the
required direction and tighten everything.
Connection using flexible
nonmetal pipes
When the connection can be easily
inspected in its full extent, there is the
chance to use a flexible pipe according
to the rules in force. The flexible pipe
must be tightly fixed using clamps
according to the rules in force.
Liquid gas: use the rubber pipe holder
«D». Always insert the gasket «B». Then
proceed with the gas connection. The
flexible pipe should be made ready for
use in such a way that:
- nowhere it can reach overtemperature,
other than room temperature, higher
than 30°C; if the flexible pipe, to reach
the cock, must run behind the range,
it must be installed as shown in picture;
- it is no longer than 1500 mm;
- it shows no throttles;
- it is not subject to traction or torsion;
- it doesn't get in touch with cutting
edges or corners;
-it can be easily inspected in order to
check its condition.
The control of preservation of the flexible
Natural gas
Liquid gas
A) Ramp with ending nut
B) Seal
C) Adjustable connection
D) Rubber pipe holder for liquid gas
pipe consistsin checking that:
- it doesn't show cracks, cuts, marks
of burnings bothon the end parts and
on its full extent;
- the material is not hardened, but
shows its normal elasticity;
- the fastening clamps are not rusted;
- expiry term is not due.
If one or more abnormalities are seen,
do not repair the pipe, but replace it.
IMPORTANT
Once installation is complete,
check the perfectseal of every
pipe fitting, using a soapy
solution, never a flame.
D