Remote Controller; Fan Button; Clock Button; Turbo Button - GE GAIRZ09IG Series Owner's Manual And Installation Instructions

GE_SAC_ENGL 01-02-2011 Page 7

Remote controller

8. FAN button

Press this button to change fan speed. There are three
speeds to choose from, or set the FAN to AUTO to let the
unit control the air flow.
9. SURROUND button
Press this button to let the air-conditioner control the
rate of cooling or heating with extra input on
surrounding room temperature from the remote
controller. Press this button once more to stop the
operation.

10. CLOCK button

Press to set the current time in the remote controller.
Adjust current time with the P LUS ( + ) and MINUS ( - )
buttons. Time changes with 1 minute intervals each
time the buttons are pressed. Time changes with
10 minute intervals when the P LUS ( + ) and MINUS
( - ) buttons are pressed for 2 seconds or longer.
11. ANTI CONDENSATION button
Press this button in COOL or DRY mode to run indoor
fan for 10 minutes after turning off the unit to prevent
condensation build up.
12. TEMP button
Press to set the desired temperature display. Select
either the set temperature, the actual indoor temperature
or the actual outdoor temperature.

13. TURBO button

In COOL or HEAT mode, press this button to let the
air-conditioner run at its full capacity. Change MODE
or fan speed to stop this operation.
Note: This mode runs continuously, if you wish to
conserve energy use the TURBO mode sparingly.
7