Abit BX6 User Manual page 65

Quick Installation
KM1 upper connector: There is an orientation pin. Connect your PS/2 mouse
connector to the connector on the back side of the motherboard.
Installing CPU fan power connector
Watch the pin position and the orientation
FAN: There is a specific orientation. Connect the three-threads fan power cable
to the fan header on the motherboard.
Pin number
1
2
3
Adjusting other jumpers
Some jumpers are reserved for future functions or are not to be adjusted in normal
operation. Adjust them according to the following recommendations.
CCMOS ¡ G A lways put jumper on pin 1 and pin 2, this is default setting.
BIOS Setup
Parameters and CPU settings After you have followed the steps described above
and completed the installation, when you power the computer on, you will see the
following message displayed
PRESS DEL TO ENTER SETUP
Press immediately Del key to enter BIOS Setup. Select Load Setup Defaults, than
enter CPU Soft Menu to set CPU parameters.
FAN1, FAN2, FAN3 (CPU FAN)
Name of the signal or signification
Ground
+12V
Sense signal
A-5