Setting The Time; Adjusting The Panel Beep Volume - GE Allegro User Manual

3. Enter the desired primary user code, and then press #.
User codes (2 to 4)
The system does not accept the same code for two different user codes.
To program/change user codes 2 to 4:
1. Press # once, and then scroll down until the desired user code is reached.
2. Press # to display the current user code (if any).
3. Enter the desired user code, and then press #.
To delete user codes 2 to 4:
1. Press # once, and then scroll until you reach the code you want to delete.
2. Press # twice to delete the user code.

Setting the time

Although the installer usually sets the time for you, you can change or reset it when
necessary. The panel uses a 12-hour clock.
To set the time:
1. Press the down arrow, and then press # to display the time.
2. Enter the current time using the numbered keys and use the arrow keys to select
AM or PM.
3. With the desired time displayed, press # to accept.

Adjusting the panel beep volume

You can adjust the panel's status, auxiliary alarm, and arming level beep volume. You
can set the volume from 0 to 5, with 0 being the lowest level (all alarms sound at the
loudest level).
To set the volume:
1. Press the down arrow twice, and then press # to display the volume.
2. Enter the desired volume level, and then press #.
Allegro Control Panel User Manual 19