Guarantee Restrictions - Philips PT919 User Manual

English
14
Problem
The shaver does
not shave as well
as it used to.
The shaver does
not work when I
press the on/off
button.
Water leaks from
the shaver after
cleaning.
6 Remove the battery.
Be careful, the battery strips are sharp.
Do not connect the shaver to the mains again after you have removed
the rechargeable battery.
guarantee and support
If you need information or support, please visit www.philips.com/
support or read the separate worldwide guarantee leaflet. If there is no
Consumer Care Centre in your country, go to your local Philips dealer.

guarantee restrictions

The shaving heads (cutters and guards) are not covered by the terms of
the international guarantee because they are subject to wear.
Troubleshooting
This chapter summarises the most common problems you could
encounter with the appliance. If you are unable to solve the problem with
the information below, contact the Consumer Care Centre in your country.
Possible cause
The shaving heads are
damaged or worn.
Long hairs obstruct the
shaving heads.
You have not inserted the
shaving heads properly.
The rechargeable battery
is empty.
The temperature of the
shaver is too high. In this
case, the shaver does
not work.
This is normal and not
dangerous.
Solution
Replace the shaving heads (see chapter
'Replacement').
Clean the shaving heads one by one (see chapter
'Cleaning and maintenance').
Make sure that the projections of the shaving heads
fit exactly into the recesses (see chapter 'Cleaning
and maintenance').
Recharge the battery (see chapter 'Charging') or
connect the shaver to the mains.
As soon as the temperature of the shaver has
dropped sufficiently, you can switch on the shaver
again.
During rinsing some water may collect between
the power unit and the housing. After rinsing this
water flows out through the socket. The power unit
is completely watertight so water cannot reach the
electronic parts of the shaver. Your shaver continues
to be absolutely safe.