Setting Of Scene Change Detection; Step 7 - Panasonic WV-CW324LE Series Operating Instructions Manual

"MOTION DET" screen
** MOTION DET **(1)
.... I .. 20
LEVEL
- +
DWELL TIME 2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END
Step 6
Move the cursor to "LEVEL" and press the [RIGHT] or [LEFT] button to adjust the level.
Repeat step 5 and 6 to adjust to optimal level.

Step 7

Move the cursor to "DWELL TIME " and select the dwell time from the following. (unit: seconds)
2S (default)/5S /10S /30S
Alarm signal will be issued once a continuously moving object is detected within the specified time.

Setting of scene change detection

This function detects a change in the subject state that occurs by covering the camera with a cloth, a cap, or others, or by changing
the camera direction largely.
Follow the procedure below.
"CAMERA SETUP" screen
**CAMERA SETUP**
SCENE1
ALC/ELC ALC
SHUTTER OFF
AGC ON(LOW)
SENS UP OFF
WHITE BAL ATW1
DNR HIGH
D&N(IR)
AUTO2
VMD SCENE CHANGE
RET TOP END
Step 1
Move the cursor to "VMD" and press the [RIGHT] or [LEFT] button to select "SCENE CHANGE".
Note:
• The Scene Change function is activated after exit from the menu.
20
Display mode screen