Control Panel - GE Monogram ZBD4200 Use And Care Manual

You can locate
your model
number on the
tub wall just
inside the door.
Throughout this
manual, features
and appearance
may vary from
your model.
Control
1. The Status
Settings
2. Load Selections
STATUS
Clean Sensor
SENSING
WASHING
RINSING SANI POTS
WASH PANS
DRYING
SANITIZED
1
The Status display tells you what is happening while the dishwasher is in operation and also any
malfunctions if they occur. The lights will come ON indicating the sequence of operation the
dishwasher is in.
Displayed during periods using CLEANSENSOR technology to measure
SENSING
the amount of soil in the load and decide if another prewash is needed. The
SENSING light is displayed only during the NORMAL and POTS PANS cycles.
Displayed during prewash and main wash periods.
WASHING
Displayed during rinse periods.
RINSING
Displayed during SPEED DRYING.
DRYING
Displayed when cycle has met sanitization conditions. Light remains ON until
SANITIZED
door is opened.
The light above the selected pad will be ON to indicate which LOAD SELECTION has been
selected.
This cycle raises the water temperature in the final rinse to sanitize your
SANI WASH
dishware. The cycle length will vary depending on the temperature of
your inlet water.
NOTE: The SaniWash cycle is monitored for sanitization requirements.
If the cycle is interrupted during or after the main wash portion or if the
incoming water temperature is so low that adequate water heating cannot
be achieved, the sanitizing conditions will not be met. In these cases, the
sanitized light will not illuminate at the end of the cycle.
For heavily soiled dishes or cookware with dried-on or baked-on soils.
POTS PANS
Everyday dishes may be included. This cycle will not remove burned-on
foods.
For loads of everyday dishes and glassware with medium soils.
NORMAL
For lightly soiled china and crystal.
CHINA
CRYSTAL
For lightly soiled dishes and glassware.
SPEED WASH
RINSE & HOLD For rinsing partial loads that will be washed later. Do not use detergent with
this cycle.

Control Panel

LOAD SELECTIONS
CHINA SPEED RINSE
NORMAL
CRYSTAL WASH &HOLD
2
Dishwasher
OPTIONS
2 4 8
POWER SPEED LOCK DELAY
(2 TIMES)
PRESOAK DRY START
3
CLEAN
5
START
RESET
4
7