Optical Drive Connector Cable - HP Compaq Presario CQ57 Maintenance And Service Manual

Reverse this procedure to install the speakers.

Optical drive connector cable

NOTE: The optical drive connector cable is included in the Cable Kit, spare part number
646119-001.
Before removing the optical drive connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
●
Optical drive (see
●
Keyboard (see
●
Top cover (see
Remove the optical drive connector cable:
1. Release the optical drive cable from the clips (1) built into the base enclosure.
2. Remove the two Phillips PM2.0×5.0 screws (2) that secure the optical drive connector to the
base enclosure.
3. Remove the optical drive connector (3) from the base enclosure.
Reverse this procedure to install the optical drive connector cable.
Battery on page 39), and then remove the following components:
Optical drive (select models only) on page
Keyboard on page 49)
Top cover on page 52)
40)
Component replacement procedures
63