GE Monogram ZEU30R Owner's Manual page 22

Before You (;all For Service...
Hadianl (ooklop
Save time
and money!
PROBLEM POSSIBLE CAUSE
PAN DETECTION " hnproper cookware being used. Use a flat, metallic pan that is 4.0"
OR SIZING NOT or larger.
WORKING
PROPERLY * Pan is imi_roperly placed. Make sure that the pan is centered on the
corresponding surtace unit.
TEMP LTD APPEARS • Time-Out ti_ature acti\z_ted. Allow the surtace unit(s) to
IN THE DISPLAY cool fin" 1/2 to 1 hour betore using again.
• Cooktop teature activated. The cooktop has a rapid heat-u l) teature
and is designed to do this.
SURFACE UNIT IS
GLOWING HOT
WHEN IT SHOULD
BE ON A LOW
POWER SETTING
SURF'ACE UNIT IS
NOT GLOWING
RF]D
"F" AND A NUMBER
APPEAR IN THE
DISPLAY AND THE
COOKTOP BEEPS
• The surtace units will only be visibly red at power levels 6-H. M power
levels i,-5, the red glow is not visible btlt the StlI't_lce tlnit is working
I)ropett):. After changing a surtilce unit f'l'Oll/ _1higher power level to
a lower power level, the red glow may disappear temporarily in order
to quickly achieve the desired temperature. If the new power setting
is greater than 5, the red glow should real)pear within several minutes.
• You haxe a flmction error code. X,_ rite down the "F:- - -" and
touch the _) (CONTROl, I,OCK) pad. Disconnect power to
the cooktop and then reconnect. If an F-code appears again, call
tot set\ice.
22