Related Manuals for GE ZEU365ABG
Summary of Contents for GE ZEU365ABG
- Page 1 ® GE Monogram Installation Instructions 36" Digital Radiant Cooktop Model ZEU365ABG ZEU36WMRABG...
-
Page 2: Table Of Contents
This appliance must be properly grounded. See “Electrical Supply”, page 4. CAUTION WARNING If you have questions concerning the Proper installation is the responsibility of the installation of this product, call the GE installer. Product failure due to improper ® Answer Center Consumer Information installation is not covered under the GE Service at 800.626.2000, 24 hours a day,... -
Page 3: Models Available
Design Information Digital Radiant Cooktop ZEU365ABG These Monogram cooktops offer a smooth Models Digital Radiant Cooktop glass surface with bridgeburner to form an Available ZEU36WMRABG elongated heating area. A beveled glass edge Digital Radiant Cooktop with provides a trimless appearance. -
Page 4: Installation Preparation
Installation Preparation Digital Radiant Cooktop • Drill and appropriate bits • Flat-blade screwdriver Tools & • Electric or hand drill • Wire strippers Materials • Pencil • 120/240 volt or 120/208 volt junction box. • Ruler • Electrical cable, 3-conductor or 4 conductor wire, as required Required •... -
Page 5: Step 1: Cut The Opening
Installation Preparation Digital Radiant Cooktop S tep Cut the Opening 19-1/4" Max. Junction 34-3/8" Max. 1-1/2" Min. Caution: Wall coverings, 2" Min. countertops and cabinets should withstand 200°F heat generated *A=30 inches minimum clearance between the top of the cooking surface and the bottom of by the cooktop. -
Page 6: Installation
Installation Digital Radiant Cooktop Place Reflective Tape Within 1/2" of Step Cutout Install Cooktop Gasket Approx. 1/8" From Edge Reflective TapeTop and Vertical Sides • Smooth rough edges of the cutout. Install • Foam gasket (supplied) is on the underside reflective tape (supplied) to the opening, of the cooktop flange all the way around, along the inside and 3/8"... -
Page 7: Step 4: Connect Electrical
Installation Digital Radiant Cooktop Step Connect Electrical Verify that power is turned off at the source When connecting to a 3-conductor branch circuit: Connect cooktop flexible power cable to • Connect cooktop red lead to branch circuit junction box: red lead. •... - Page 8 NOTE: While performing installations described in this book, safety glasses or goggles should be worn. To obtain specific information concerning any ® Monogram product or service, call GE Answer Center consumer information service at 800.626.2000—any time, day or night. For Monogram local service in your area, call 1-800-444-1845.