Westerbeke 8.0KW-60Hz Service Manual page 17

ENGINE DISASSEMBLY
15.
Remove governor assembly.
a. Remove the tie rod cover.
b. Remove the spring from the tie rod with pliers to
disconnect the tie rod from t\1e fuel injection pomp.
c.
Remove the governor assembly.
16. Remove governor weight.
a. Remove the sliding sleeve.
b. Remove the sliding sleeve shaft and governor weigbts.
17. Fuel injection pump removaL
a. Remove the tie rod cover.
b. Remove the spring from the tie rod with pliers to
disconnect the tie rod from the fuel fujection pomp.
18.
Remove the fuel injection pump.
NOTE:
Keep a record of the thickness of the shims for
in11tallation. .
19.
Remov~
..
the
pressure relief valve from
blOCk .•
ii'····· . . , " .
LOCATEiiJusr' . " . .
\ 'UNDER THE .
•
. . FUEL '
, : PUMP DN THE
, ' ENGINE BLGCK.'
.
.
'.
..
-
.
;
.
20. Remo~e th~r;;~ker shaft assembly.' ',' .
a. Remove the bolts that hold the rocker stays in position
and remove the rocker shaft assembly. .
b. Remove the valve caps.
"'iIIISASSEMIBLlIIG THE
• ROCKER SHAFT ASSEMBLY
21. Disassemble the rocker
shaft
assembly. Put identifica-
tion on each rocker arm as
to
its location on the rocker
shaft.
22. Remov~ the .cylinder head bolt. Loosen the cylinder
head bolts in two or three steps in the sequence shown.
. NiltE:
it
~ny p~ris
on the
g,iinde~
head are faUlty, check
the cylinder head bolts for tightness with a torque wrench "
before loosening them. .
07
G9
$3 .5 .10" 1118
.12 .14 .13
CYLINDER HEAD BOLT LOOSENING
SEQUENCE
".3'tYEINDER .
11
23. Remove the cyfuider head assembly.
Lift
the cylinder
head straight up with a hoist.
NOTE: if
the gasket is seized
and the cylinder hedd cannot
be separated from the cylinder block, tap around the thick
Siile1WrtiOI:! of the cylinder head with a plastic hammer.
. ORDER OF DISASSEMBLY
)
)