Assembly And Installation - CHIEF SLBU Installation Instructions Manual

SLBU/SLMU

ASSEMBLY AND INSTALLATION

Remove Screw Adapters from SLBU/SLMU Legs
1. Press locking buttons on SLBU/SLMU leg (B) firmly and
simultaneously push clip cover toward enclosed sliding stud
mount bracket and screw. (See Figure 1)
2. Screw adapter and attached height-adjustment nut will be
released. Set aside for later use. (See Figure 1)
3. Repeat Steps 1-2 for each leg to be used in installation.
(B)
1
locking button x 2
clip cover
(side view)
2
Figure 1
Attach Projector to SLBU/SLMU
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer's responsibility to make sure the combined weight of
all components attached to the SLBU-SLMU interface
brackets does not exceed 50 lbs (22.68 kg).
1. Determine proper size screw to insert into projector. Test
Phillips screws (M, N, P, Q and R) provided until one fits the
projector holes.
2. Insert screws through M4 flat washers (S), screw adapters
with height-adjustable nuts and into projector holes. (See
Figure 2)
6
sliding stud mount
bracket and screw
height-adjustment nut
screw adapter
NOTE:
Only use washers (S) if using M or N screws to attach
screw adapters to projector.
2
(M, N, P, Q or R)
Figure 2
3. Adjust height-adjustment nuts to desired level.
Figure 3)
NOTE:
Height-adjustment nuts should be adjusted as low as
possible while ensuring that the legs will always clear
any elevated surfaces on the projector. All nuts must be
adjusted to the same level to ensure an even mount.
IMPORTANT ! : The optional Universal Hardware Kit -
Long Screws (see Parts drawing) may be used if there is
interference with any part of the projector, and more
height is required to clear elevated surfaces of the
projector.
3
fully lowered
Figure 3
Installation Instructions
(S) x 3 or 4
(with M or N only)
screw adapters
with nuts
(See