Programming The Autoflush Timer Clock - GE OSMONICS E4 Series Installation, Operation And Maintenance Manual

STEPS
1. While holding down the Clock Key (
the current minute.
2. While holding down the Clock Key (
the current minute.
3. While holding down the Clock Key (
the current minute.
NOTE:
If the days are flashing, it indicates the day of the week was not set
when setting the time. The timer cannot be programmed unless the
day of the week is entered. Each year, in the spring, press the Button
to advance the time one hour (Daylight Savings Time). In the fall,
press the button to set the timer back one hour (Daylight Savings
Time).

2.15.3 Programming the Autoflush Timer Clock

This timer will accept up to 20 programs. Each program consists of the fol-
lowing:
1. ON/OFF Command
2. Time of Day (hours and minutes)
3. Single day or multiple days
IMPORTANT:
If the h and m keys are held down for longer than 2 seconds,
the numbers will advance rapidly.
The current time of day and day of the week must be set
prior to programming the timer. See Section 2.15.3 (Setting
Up the Autoflush Timer).
12
⊗
), press the h key to advance to
⊗
), press the h key to advance to
⊗
), press the h key to advance to