Sounding Arpeggios Automatically (Tutorial)
Clearing Arpeggio Step Data
Use the procedure below to clear preset step data or
step data that was edited using Step Edit (page E-25)
and create new step data from scratch.
• Note that the variation type cannot be cleared.
1.
While the arpeggio type selection screen is
displayed, press the
2.
Use the
dt
(w) and
"Clear Step" and then press the
button.
This should cause "Clear?" to appear on the display.
3.
Press the
em
(ENTER) button again.
This will display a confirmation message ("SURE?").
4.
eo
Press the
(YES) button.
The message "Complete!" will appear on the display
when the data is deleted.
Renaming an Arpeggio
After editing an arpeggio, you can give it a name and
save it as a user arpeggio.
1.
Perform steps 1 through 2 of the procedure
under "Editing an Arpeggio", (page E-25).
2.
ds
Use the
(u),
(i) buttons to select "NameEdit", and then
em
press the
(ENTER) button.
3.
Edit the name as desired.
E-28
ep
(EDIT) button.
ek
(q) buttons to select
em
(ENTER)
dt
ek
(w),
(q), and
el