To Select A Different Arpeggio For Each Zone; To Turn The Arpeggio For A Specific Zone On Or Off; Editing An Arpeggio - Casio Privia PX-5S User Manual

To select a different arpeggio
for each zone
1.
Hold down the bn
the arpeggio type selection screen appears
on the display.
This will cause the button's lamp to light.
2.
dk
Use the (ZONE, –/+) buttons to display the
number of the zone you want to select.
3.
After making sure that
arpeggio number, display the number of the
arpeggio you want to select for the zone.
• Repeat steps 2 and 3 as many times as necessary to
select arpeggios for each of the zone.
To turn the arpeggio for a
specific zone on or off
1.
Hold down the bn
the arpeggio type selection screen appears
on the display.
This will cause the button's lamp to light.
2.
ds
Use the (u),
(i) buttons to select "ZONE".
3.
Use the eo minus (–) and plus (+) buttons to
turn the arpeggio of the zone on or off.
NOTE
• Note that no arpeggio also will play if the zone has
been muted. To unmute a zone, press the
button to exit the arpeggio type selection screen, and
then press the two dk
same time.
(ARPEGGIO) button until
Zone number
is next to the
(ARPEGGIO) button until
dt ek
(w), (q), and
dr
(EXIT)
(ZONE, –/+) buttons at the

Editing an Arpeggio

There are two arpeggio types: step type and variation
type.
• With a step type arpeggio, you can edit its steps and
its parameters. A step type arpeggio can contain up
to 16 steps. You can change the following settings for
each step.
TYPE : Specifies which note of the arpeggio should be
played in each step, in relation to the lowest note
(L1) or the highest note (U1) of the arpeggio. There
is also a TYPE (P2-P5) that can be used to sound
up to five notes at the same time.
NOTE : When you want to shift the note from the
keyboard key that is pressed, use this setting
specify the shift value in semitone steps.
VELO : Specifies the volume level.
CTRL : This is MIDI control data.
• With a variation type arpeggio, you can edit only its
parameters.
1.
Select the arpeggio type you want to edit.
2.
Press the
3.
Use the
"Step Edit" and then press the
button.
• The "Step Edit" option will not be displayed if you
selected a variation type arpeggio in step 1, above.
el
Sounding Arpeggios Automatically (Tutorial)
ep (EDIT) button.
dt ek
(w) and (q) buttons to select
em
(ENTER)
E-25