Table of Contents
Advertisement
Chapter 15 Quality of Service (QoS)
15.4 The Queue Setup Screen
Click QoS > Queue Setup to open the screen as shown next.
Use this screen to configure QoS queue assignment.
Figure 93 QoS Queue Setup
The following table describes the labels in this screen.
Table 63 QoS Queue Setup
LABEL
Add
No.
Active
Name
Interface
Priority
Weight
Buffer
Management
Rate Limit
Modify
Apply
166
DESCRIPTION
Click this button to create a new entry.
This is the index number of this entry.
Select the check box to enable the queue.
This shows the descriptive name of this queue.
This shows the name of the ZyXEL Device's interface through which traffic
in this queue passes.
This shows the priority of this queue.
This shows the weight of this queue.
This shows the queue management algorithm used by the ZyXEL Device.
This shows the maximum transmission rate allowed for traffic on this
queue.
Click the Edit icon to go to the screen where you can edit the queue.
Click the Remove icon to delete an existing queue. Note that subsequent
rules move up by one when you take this action.
Click Apply to save your changes back to the ZyXEL Device.
P-870H/HW Series User's Guide
Advertisement
Table of Contents
