Table of Contents
Advertisement
2.5.3
SATA Configuration
While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA
port.
OnChip SATA Channel [Enabled]
Enables or disables onboard channel SATA port. Configuration options: [Disabled] [Enabled].
The following three items appear only when you set the above item to [Enabled].
OnChip SATA Type [AHCI]
Allows you to set the SATA configuration.
[IDE]
Set to [IDE] when you want to use the Serial ATA hard disk drives as
Parallel ATA physical storage devices.
[RAID]
Set to [RAID] when you want to create a RAID configuration from the SATA
hard disk drives.
[AHCI]
Set to [AHCI] when you want the SATA hard disk drives to use the AHCI
(Advanced Host Controller Interface). The AHCI allows the onboard storage
driver to enable advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to internally
optimize the order of commands.
SATA Port 5 - Port 6 [AHCI]
This item only appears when OnChip SATA Type is set to [AHCI]. If SATA port 5
and port 6 are configured as [AHCI], the ports can only be used under OS with driver
installed. Set to [IDE] instead of [AHCI] to access devices on SATA port 5 and port 6
before entering OS. Configuration options: [AHCI] [IDE]
OnChip SATA MAX Speed [SATA 6.0 Gb/s]
Selects SATA speed. Configuration options: [SATA 6.0Gb/s] [SATA 3.0Gb/s]
S.M.A.R.T. Status Check [Enabled]
S.M.A.R.T. (Self-Monitoring, Analysis and Reporting Technology) is a monitor system. When
read/write of your hard disk errors occur, this feature allows the hard disk to report warning
messages during the POST. Configuration options: [Enabled] [Disabled]
ASUS F2A85-M2
2-11
Advertisement
Table of Contents
