Mounting; Orientation; Rigging - Chauvet SlimPAR User Manual

Mounting

Orientation

Rigging

Mounting Diagram
SlimPAR™ HEX 3 IRC User Manual Rev. 2
Before mounting the product, read and follow the safety recommendations indicated in
the Safety Notes.
The SlimPAR™ HEX 3 IRC may be mounted in any position; however, make sure
adequate ventilation is provided around the product.
·
Before deciding on a location, always make sure there is easy access to the product
for maintenance and programming.
·
Make sure that the structure or surface onto which you are mounting the product
can support the product's weight (see the
·
When mounting the product overhead, always use a safety cable. Mount the
product securely to a rigging point, such as an elevated platform or a truss.
·
When rigging the product onto a truss, you should use a mounting clamp of
appropriate weight capacity. The brackets have a 13-mm hole, which is appropriate
for this purpose.
·
When power linking multiple products, you must always consider the length of the
power linking cable and mount the products close enough for the cable to reach.
·
The bracket adjustment knobs allow for directional adjustment when aiming the
product to the desired angle. Only loosen or tighten the bracket knobs manually.
Using tools could damage the knobs.
·
The double-bracketed yoke also serves as a floor support. When mounting the
product on the floor, make sure that the product and cables are away from people
and vehicles.
Safety Cable
0
Overhead
Mounting
Technical Specifications).
Mounting Clamp
Double-Bracketed
Yoke
Bracket Adjustment Knobs
Floor
Mounting
Page 9 of 19