Table of Contents
Advertisement
Operation
Fan Wait
System Default
Edit Custom
-16-
Stop the fan during a blackout.
1. Go to MENU > SPECIAL > FAN_WAIT.
2. Select ON or OFF.
Default all product parameters to their default values.
1. Go to MENU > EXTRA.
2. Press <ENTER> (PASSWORD) will show on the display.
3. Press <ENTER> (**** will show on the display).
4. Enter the password, as explained in Keylock.
5. Use <UP> to select DEFAULT.
6. Press <ENTER> (NO will show on the display).
7. Select YES and press <ENTER> to default the product or press <MENU> to exit.
Program up to 255 steps in a single custom program.
1. Go to MENU > EDIT.
2. Press <ENTER> to go to STEP.
3. Press <ENTER> to select a value. The current value (001~255) will show on the LCD.
4. Press <UP> or <DOWN> to select a new value.
5. Press <ENTER> to accept the value.
6. Press <ENTER> to go to PAN.
7. Repeat steps "1" through "6" for TILT, SPEED, COLOR, GOBO1, GOBO2,
GOBO2ROT, PRISM, PRISMT, IRIS, FOCUS, DIMMER, STROBE, and TIME.
8. Press <ENTER> to go to USE.
9. Select YES to save the settings for this step or NO to delete them.
10. Repeat steps "3" to "8" for the other steps.
The product will execute all the steps in the CUSTOM program and stop.
To make the product start over, add a last step whose duration is 0 seconds.
Example:
Step 1:
Time = 5
Step 2:
Time = 4
Step 3:
Time = 6
Step 4:
Time = 0
Step 5:
Time = 0
Step 255
Time = 0
Use = Yes
Use = Yes
Use = Yes
Use = Yes
(This step creates a loop)
Use = No
(Unused steps)
Use = No
Q-Spot™ 560-LED User Manual Rev. 08
Advertisement
Table of Contents
