Integra DTR-50.2 Instruction Manual page 35

Hide thumbs Also See for DTR-50.2:
Table of Contents

Advertisement

Selecting the previously selected channel
Press Return to select the previously selected
channel.
Selecting Channels on the AV Receiver
1
Press Tuner repeatedly to select "SIRIUS".
2
Press Tuning Mode repeatedly to select Channel
Search mode or Category Search mode.
3
Press Enter repeatedly to select a category.
4
Use Tuning / to select a channel.
In Channel Search mode, you can select any channel.
In Category Search mode, you can only select chan-
nels from the currently selected category.
Presetting Channels
You can store a combination of up to 40 of your favorite
SIRIUS Satellite Radio channels and FM/AM radio sta-
tions as presets.
1
Tune into the SIRIUS channel that you want to
store as a preset.
2
Press Memory on the AV receiver.
The preset number flashes.
3
While the preset number is flashing (about 8 sec-
onds), use Preset
select a preset from 1 through 40.
4
Press Memory on the AV receiver again to store
the channel.
The channel is stored and the preset number stops
flashing.
Repeat this procedure for all of your favorite SIRIUS
Satellite Radio channels.
Selecting presets
To select a preset, use Preset
receiver or the remote controller's CH +/–.
Tip
• You can also use the number buttons to select a preset directly.
Deleting presets
1
Select the preset that you want to delete.
See the previous section.
2
While holding down Memory press Tuning
Mode on the AV receiver.
The preset is deleted and its number disappears from
the display.
/
on the AV receiver to
/
on the AV
SIRIUS Parental Lock
With SIRIUS Parental Lock, you can lock out channels
that you do not want to receive and use a 4-digit PIN num-
ber to prevent others from unlocking them.
1
Press Receiver followed by Setup.
The main menu appears onscreen.
2
Use / to select "Hardware Setup", and then
press Enter.
The "Hardware Setup" menu appears.
7. Hardware Setup
1. Remote ID
2. Multi Zone
3. Tuner
4. HDMI
5. Auto Power Down
6. Network
7. Firmware Update
3
Use / to select "Tuner", and then press Enter.
4
Use / to select "SIRIUS Parental Lock", and
then press Enter.
The following screen appears.
SIRIUS Parental Lock
Enter Code
0
1
2
3
Note
• If the "SAT Radio Mode" is set to "None"
"SIRIUS Parental Lock" setting is not available.
5
Use
/
to select a number on the screen, and
then press Enter.
Repeat this for each of the four digits in the PIN
number.
If you're entering the PIN number for the very first
time, the default is "0000". The following screen
appears.
SIRIUS Parental Lock
Edit Code
Parental Lock
If you've already set a PIN number, you must enter
the correct PIN to get to this screen. If you enter the
wrong PIN, the message "Wrong Code!" appears
and you'll have to enter the PIN again.
Note
• The "SIRIUS Parental Lock" setting cannot be set unless
the AV receiver and the SiriusConnect receiver are con-
nected.
4
5
6
7
8
9
33), the
(➔
En
35

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents