Integra DTR-50.2 Instruction Manual page 29

: Listening area
Note
• Make the room as quiet as possible. Background noise and Radio
Frequency Interference (RFI) can disrupt the room measure-
ments. Close windows, televisions, radios, air conditioners, flu-
orescent lights, home appliances, light dimmers, or other
devices. Turn off the cell phone (even if it is not in use) or place
it away from all audio electronics.
• The microphone picks up test tones which played through each
speaker as Audyssey MultEQ
Setup run.
• Audyssey MultEQ Room Correction and Speaker Setup cannot
be performed while a pair of headphones is connected.
1
Turn on the AV receiver and the connected TV.
On the TV, select the input to which the AV receiver
is connected.
2
Set the speaker setup microphone at the Main Lis-
, and connect it to the Setup
tening Position
Mic jack.
Speaker setup microphone
The speaker setting menu appears.
3
When you've finished making the settings, press
Enter.
MultEQ: Auto Setup
Speakers Type(Front)
Powered Zone 2
Subwoofer
• If your front speakers are bi-amped, you must
select "Bi-Amp" in the "Speakers Type(Front)"
51). For hookup information, see "Bi-
setting (➔
amping the Front Speakers"
• If you change "Powered Zone 2" setting, refer to
"Setting the Powered Zone 2" for more details
(➔ 79).
• If you are using a subwoofer(s), select "Yes" in the
51). If not, select "No" and skip
"Subwoofer" (➔
step 4.
TV
to : Listening position
® Room Correction and Speaker
Setup Mic jack
Normal
Not Act
Yes
15).
(➔
4
If you use a powered subwoofer(s), adjust the sub-
woofer volume level to 75dB.
Test tones are played through the subwoofer. Use the
volume control on the subwoofer.
Note
• If your subwoofer does not have a volume control, disre-
gard the level displayed and press Enter to proceed to the
next step.
• If you set the subwoofer's volume control to its maximum
and the displayed level is lower than 75 dB, leave the sub-
woofer's volume control at its maximum and press Enter
to proceed to the next step.
5
Press Enter.
Audyssey MultEQ Room Correction and Speaker
Setup starts.
Test tones are played through each speaker as
Audyssey MultEQ Room Correction and Speaker
Setup runs. This process takes a few minutes. Please
refrain from talking during measurements and do
not stand between speakers and the microphone.
Do not disconnect the speaker setup microphone
during Audyssey MultEQ Room Correction and
Speaker Setup, unless you want to cancel the setup.
6
Place the setup microphone at the next position,
and then press Enter.
Audyssey MultEQ performs more measurements.
This takes a few minutes.
7
When prompted, repeat step 6.
8
Use / to select an option, and then press Enter.
MultEQ: Auto Setup
- - Review Speaker Configuration - -
Subwoofer
Front
Center
Surround
Front Wide
Front High
Surr Back
Surr Back Ch
Save
Cancel
The options are:
Save:
Save the calculated settings and exit
Audyssey MultEQ
.
Setup
Cancel:
Cancel Audyssey MultEQ
.
Speaker Setup
Note
• You can view the calculated settings for the speaker con-
figuration, speaker distances, and speaker levels by using
/ .
9
Disconnect the speaker setup microphone.
Yes
40Hz
TV
40Hz
100Hz
None
100Hz
120Hz
2ch
Room Correction and Speaker
Room Correction and
En
29