Integra DTR-40.3 Instruction Manual page 81

Important Note Regarding Video Playback
The AV receiver can upconvert component video, S-
Video, and composite video sources for display on a TV
connected to the HDMI output(s). However, if the picture
quality of the source is poor, upconversion may make the
picture worse or disappear altogether.
In this case, try the following:
1 If the video source is connected to a component
video input, connect your TV to the
COMPONENT VIDEO MONITOR OUT.
If the video source is connected to an S-Video input,
connect your TV to a MONITOR OUT S.
If the video source is connected to a composite video
input, connect your TV to the MONITOR OUT V.
2
On the main menu, select "Input/Output Assign"
and then "Component Video Input"
If the video source is connected to COMPONENT
VIDEO IN 1, select the relevant input selector, and
assign it to "IN1".
If the video source is connected to COMPONENT
VIDEO IN 2, select the relevant input selector, and
assign it to "IN2".
If the video source is connected to COMPONENT
VIDEO IN 3, select the relevant input selector, and
assign it to "IN3".
If the video source is connected to an S-Video input
or composite video input, select the relevant input
selector, and assign it to "- - - - -".
page 45).
(➔
En
81