Yamaha CYGNUS.X XC125 Owner's Manual page 43

Hide thumbs Also See for CYGNUS.X XC125:
Table of Contents

Advertisement

screwing it in), and then remove it
again to check the oil level.
NOTE:
The engine oil should be between the
minimum and maximum level marks.
1
2
ZAUM00**
1. Maximum level mark
1. Minimum level mark
4. If the engine oil is below the mini-
mum level mark, add sufficient oil
of the recommended type to raise
it to the correct level.
5. Insert the dipstick into the oil filler
hole, and then tighten the oil filler
cap.
PERIODIC MAINTENANCE AND MINOR REPAIR
To change the engine oil and clean
the oil strainer
1. Start the engine, warm it up for sev-
eral minutes, and then turn it off.
2. Place an oil pan under the engine
to collect the used oil.
3. Remove the engine oil filler cap and
drain bolts to drain the oil from the
crankcase.
cC
When removing the engine oil drain
bolt, the O-ring, spring, and oil
strainer will fall out. Take care not to
lose these parts.
1
ZAUM00**
1. Oil filler cap
6-9
ECA10410
ZAUM00**
1. Engine oil drain bolt A
ZAUM00**
1. Engine oil drain bolt B
4. Clean the oil strainer with solvent,
and then check it for damage and
replace it if necessary.
5. Check the O-ring for damage and
replace it if necessary.
6. Install the oil strainer, spring, O-ring
1
2
1
3
4
5
6
7
1
8
9

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cygnus x

Table of Contents