Replacing A Headlight Bulb Or A Front Turn Signal Light Bulb - Yamaha TEO'S XN125 Owner's Manual

CAUTION:
Do not use a fuse of a higher
amperage rating than recommended
to avoid causing extensive damage
to the electrical system and possibly
a fire.
3. Turn the key to "ON" and turn on
the electrical circuits to check if the
devices operate.
4. If the fuse immediately blows again,
have a Yamaha dealer check the
electrical system.
6
5. Install the panel.
PERIODIC MAINTENANCE AND MINOR REPAIR
EC000103
1
ZAUM0065
1. Bulb holder
2. Headlight connector
Replacing a headlight bulb or
a front turn signal light bulb
Replacing a headlight bulb
1. Remove cowling C (See page 6-7
for cowling removal and installation
procedures).
2. Remove the headlight connector.
3. Remove the headlight bulb holder
by turning
counterclockwise.
4. Remove the defective bulb.
6-27
1
2
ZAUM0066
1. Bulb
WARNING
EAUM0035
Headlight bulbs get very hot.
Therefore, keep flammable products
away from a lit headlight bulb, and
do not touch the bulb until it has
cooled down.
5. Place a new bulb into position, and
then secure it with the bulb holder.
it 1/4 turn
1
1
EW000119