Reseting Oil Change Indicator - Yamaha XMAX YP250R Sports Owner's Manual

3. Remove the engine oil filler cap
and the engine oil drain bolt to
drain the oil from the crankcase.
ZAUM0686
1. Engine oil drain bolt
4. Check the washer for damage
and replace it if necessary.
1
ZAUM0129
1. Engine oil drain bolt
2. Washer
PERIODIC MAINTENANCE AND ADJUSTMENT
5. Install the washer and the engine
oil drain bolt, and then tighten the
drain bolt to the specified torque.
Tightening torque:
Engine oil drain bolt:
20 Nm (2.0 m•kgf, 14 ft•lbf)
1
1
TIP
Make sure that the washer is properly
seated.
6. Refill with the specified amount
of the recommended engine oil,
and then install and tighten the oil
filler cap.
Recommended engine oil:
See page 8-1
Oil change quantity:
1.30 L (1.37 US qt, 1.14 Imp.qt)
NOTICE
G
Do not use oils with a diesel
2
specification of "CD" or oils of
a higher quality than specified.
In addition, do not use oils
labeled "ENERGY CONSER-
VING II" or higher.
6-11
G
Be sure no foreign material
enters the crankcase.
7. Start the engine, and then let it
idle for several minutes while
checking it for oil leakage. If oil is
leaking, immediately turn the
engine off and check for the cau-
se.
8. Reset the oil change indicator.
To reset the oil change indicator
1. Turn the key to "ON".
2. Hold the "OIL CHANGE" button
pushed for 15 to 20 seconds.
ECA11670
1. "OIL CHANGE" button
6