01 Safety; Seatbelts - Volvo C30 Owner's Manual

Hide thumbs Also See for C30:
Table of Contents

Advertisement

01 Safety

Seatbelts

01
General information
Tensioning the hip strap. The belt must be posi-
tioned low down.
Heavy braking can have serious consequences
if the seatbelts are not used. Ensure that all
passengers use their seatbelts. It is important
that the seatbelt lies against the body so it can
provide maximum protection. Do not lean the
backrest too far back. The seatbelt is designed
to protect in a normal seating position.
Putting on a seatbelt
Pull the seatbelt out slowly and secure it by
pressing the buckle into the lock. A loud
"click" indicates that the seatbelt has
locked.
16
Releasing the seatbelt
Press the red lock button and then let the
seatbelt retract. If the seatbelt does not
retract fully, feed the seatbelt in by hand so
that it does not hang loose.
The seatbelt locks and cannot be withdrawn:
if it is pulled out too quickly.
during braking and acceleration.
if the car leans heavily.
Keep in mind the following:
do not use clips or anything else that can
prevent the seatbelt from fitting properly
ensure that the seatbelt is not twisted or
caught on anything
the hip strap must be positioned low down
(not over the abdomen)
tension the hip strap over the lap by pulling
the diagonal shoulder belt as illustrated.
WARNING
The seatbelts and airbags interact. If a seat-
belt is not used or is used incorrectly, this
may diminish the protection provided by the
airbag in the event of a collision.
WARNING
Each seatbelt is designed for only one per-
son.
WARNING
Never modify or repair the seatbelt yourself.
Volvo recommends that you contact an
authorised Volvo workshop. If the seatbelt
has been subjected to a major load, such as
in conjunction with a collision, the entire
seatbelt must be replaced. Some of the
seatbelt's protective properties may have
been lost even if the seatbelt does not
appear damaged. The seatbelt must also be
replaced if it shows signs of wear or dam-
age. The new seatbelt must be type-
approved and designed for installation at
the same location as the replaced seatbelt.
WARNING
The rear seat is designed for a maximum of
two passengers.

Advertisement

Table of Contents
loading

Table of Contents