Ink Adheres To The Recording Surface; The Product Does Not Function; All Lights Are Off; Lights Came On And Then Went Out - Epson Discproducer PP-50BD User Manual

❏ If you print continuously for an extended period, the discs may temporarily stop feeding
or the printing may pause for a while. This is to slow down the printing speed and
prevent the product mechanism from overheating and being damaged. If this happens,
you can continue to print, but we recommend stopping and leaving the product for about
thirty minutes with the power on. (The product will recover after about 3 hours with the
power off.) After you restart, the product will print at normal speed.
❏ Uninstall the printer driver, then reinstall it.
& See "Uninstalling Software" on page 22.

Ink Adheres to the Recording Surface

❏ Depending on the type of disc, ink may adhere to the recording surfaces if they are
stacked right after printing. Make sure of the type of disc before using.
❏ Keep the printed surface of the disc away from other discs until ink on the printed disc
is completely dry, otherwise marks or smudges may be left at the area where discs
come into contact.

The Product Does Not Function

All Lights Are Off

❏ Press the P Power button to make sure the product is on.
❏ Turn off the product, and make sure the power cord is securely plugged in.
❏ Make sure your outlet works and is not controlled by a wall switch or timer.

Lights Came On and then Went Out

The product's voltage may not match the outlet rating. Turn off the product and unplug it
immediately. Then check the label on the back of the product.
Caution:
c
If the voltage does not match, DO NOT PLUG YOUR PRODUCT BACK IN. Contact your
dealer.
92
Troubleshooting