Chapter 2 Publishing Discs; Introduction; Turning Power On/Off - Epson Discproducer PP-50BD User Manual

Chapter 2
Publishing Discs

Introduction

This section guides you through the procedures for creating and printing CDs/DVDs/BDs.
Note:
For information on CDs/DVDs/BDs, see the following section.
& See "Discs" on page 101.

Turning Power On/off

This section describes how to turn on/off power.
Turning power on
1. Connect the power cable.
2. Press P Power button until the power light flashes.
Power light flashes in green, then stays on.
Turning power off
Press the P Power button. The
power is turned off.
Caution:
c
❏ Fan will operate after turning power off, but it will automatically stop after 15 minutes.
❏ If the product is operating, wait for 10 seconds after operation is stopped; then turn off
power.
❏ The product may not be recognized by the computer when the power is turned back on
while fan is operating. In this case, disconnect the USB cable and connect it again.
Note:
❏ If turning off the product while power on the PC is on, follow the procedure below. If the product
is turned off without following the procedure, data in the PC maybe damaged.
1. If Total Disc Maker, Total Disc Monitor, or Total Disc Setup is running, close the software.
2. Double click "Safely Remove Hardware" on the task tray.
3. Select a drive on the product and select Stop.
Power light will flash in green then turn off; then
23
Publishing Discs