Using The Product - Epson Discproducer PP-50BD User Manual

❏ Avoid places subject to dust, shocks, vibrations, or cigarette smoke.
❏ Leave enough room around the product to allow for sufficient ventilation.
❏ Place the product near a wall outlet where the plug can be easily unplugged.

Using the Product

Observe the following when using the product:
❏ Do not insert objects in the product.
❏ Take care not to spill liquid on the product.
❏ Do not use aerosol products that contain flammable gases inside or around this
product. Doing so may cause fire.
❏ Always turn the product off using the P power button. When this button is pressed, the
power light flashes. Do not unplug the product or turn off the power to the outlet
until the
❏ Leave the ink cartridges installed. Removing the cartridges can dry out the print head
and may prevent the product from printing.
❏ Before closing the disc cover, make sure that there is no disc left near stacker 3 and
that discs in stacker 3 are not slanted. Otherwise, an error may occur when you close
the disc cover.
❏ Be careful not to trap your fingers when closing the disc cover.
❏ The product uses galvanized sheet metal, and this may cause rusting at the edges;
however, this does not cause any harm to the function of the product.
❏ Do not place any drink or liquid on the product as penetration by liquid inside the
product will cause a malfunction.
❏ For PP-50BD: Do not open disc cover while running a job (busy indicator is flashing),
unless the application instructs you to add or remove discs. This may affect write quality
or print quality. Also, for safety reasons, do not put your hands inside the product while
it is beeping, as the arm is still moving.
❏ For PP-50: When you have opened the disc cover while running a job (busy indicator is
flashing), make sure that internal light has turned off and that the arm has stopped
moving before performing any operation such as loading or taking out discs. Do not put
your hands inside the product or operate stackers while the arm is moving. Also, open
and close the disc cover gently.
power light stops flashing.
Important Notice and Safety Instructions
9