Advertisement
SINGLE BUTTON ARMING
If desired, the Arming Keys can be set for Single Button Arming by following
prompts to store a valid user code in the keypad. (See the system User Guide for
details on programming user codes.)
Enabling Single Button Arming
1. Press and hold down the
seconds. The screen displays the keypad's address.
2. Press
to move to the USER CODE entry screen.
3. Enter a valid four digit user code between 0000 – 9999 and press
save and continue.
Recommended: Set a dedicated user code for this feature.
The user code must be entered for each keypad in the system where Single
Button Arming is desired.
4. At the 'Delete Devices?' screen, press
Disabling Single Button Arming
1. Press and hold down the
seconds. The screen displays the keypad's address.
2. Press
to move to the USER CODE entry screen.
3. Enter
and then press
screen.
4. Press
to decline and exit.
When Single Button Arming is disabled, a valid user code is required to arm the
system with the Arming keys.
FUNCTION KEYS
The Function keys may be programmed by the installer
for special functions or alarm activations. Key pairs
may also be programmed for alarm activations.
To activate the Function keys, press and hold the key
for at least 2 seconds; key pairs are activated
immediately.
Check with the system installer for more information.
COMMERCIAL STAY MODES
For commercial controls, if Stay Mode
2 is programmed, refer to the
control's manuals and the table on
the right for Stay mode arming.
SOUNDER
• Two-tone sound = burglary and audible panic alarms
• Pulsing sound = fire or carbon monoxide alarms
Refer to the system's user guide for details of audible notifications.
and
keys at the same time for 3
to decline and exit.
and
keys at the same time for 3
to save and move to 'Delete Devices?'
A or
B or
C or
D
Commercial Systems Stay Modes
+ 1 = Stay Mode 1
+ 2 = Stay Mode 2
= Stay Mode 3 (both Stay 1 and
Stay 2 modes)
- 3 -
to
and
and
and
Advertisement
