Advertisement
View Event Log
1. Press
and then
2. Enter the Master User Code at the 'Enter Your Code' prompt and press
3. Press
to move forward or
4. To exit, press any key except the
Reboot Keypad
1. Press
and then
the LEDs flash for several seconds.)
Set User Codes
1. Press
and then
2. Enter the Master User Code at the 'Enter Your Code' prompt and press
to see a user option screen.
Add a User: Press
• At 'Enter User No.' screen, enter a unique two-digit number and press
.
• At the 'New User Code' prompt, enter a new four-digit user code and press
.
Note: Four digit user codes options: 0000 – 9999.
•
The keypad will confirm the User setting and exit the Settings mode:
Confirmation
Meaning
Short "ding"
User created successfully
Long "ding"
Error– that user number already has a user code assigned.
User not created – try again. If necessary, delete the user
No sound
and try again.
Delete a User: Press
• At 'Enter User No.' prompt, enter the desired two-digit number and press
.
• The keypad will "ding" to confirm the User deletion and exit the Settings
mode.
Assign Attributes: Press
•
At 'Enter User No.' screen, enter the desired two-digit user number and press
.
The Assign Attributes menu appears:
1. Authority Level
2. Access Group
3. User Partition
4. RF User Number
5. Pager On or Off
Refer to the system User Guide for assigning the appropriate user settings in the
Assign Attributes Menu.
to select the 'View Event Log'.
to move backward through events.
and
to Reboot the keypad. (The keypad beeps and
to select 'Set User Code'.
to select 'Add a User'.
to select 'Delete a User'.
to select 'Assign Attr.'.
- 2 -
keys.
.
Advertisement
