By default, all outgoing IP traffic from the LAN is not restricted. The Outbound Filter allows you to create a filter rule to block outgoing IP traffic by

specifying a filter name and at least one condition below. All of the specified conditions in this filter rule must be satisfied for the rule to take effect.

To access the OUTBOUND FILTER settings window, click on the OUTBOUND FILTER button in the ADVANCED tab

ADD OUTBOUND IP FILTER

To create the new policy and fill in the filter name.

Choose ICMP, TCP/UDP, TCP or UDP on the Protocol.

Type Source IP address, Source Subnet Mask and Source Port (can

be single port or port range in "start port::end port" syntax )

Type Destination IP address, Destination Subnet Mask and

Destination Port (can be single port or port range in "start port::end port"

syntax )

Set the policy schedule on the Schedule, Always or never, or View

Available Schedules

Please click Add/Apply button to add the policy in the list.