Completing The Parts Replacement - Lenovo ThinkCentre 3025 User Manual

Completing the parts replacement

After completing the installation or replacement for all parts, you need to close the
computer cover and reconnect cables. Depending on the parts you installed or
replaced, you might need to confirm the updated information in the Setup Utility
program. Refer to Chapter 4, "Using the Setup Utility," on page 41.
To close the computer cover and reconnect cables to your computer, do the
following:
1. Make sure that all components have been reassembled correctly and that no
tools or loose screws are left inside your computer. See "Locating components"
on page 10 for the locations of various components in your computer.
2. If you have removed the front bezel, reinstall it. See "Removing and reinstalling
the front bezel" on page 15.
3. Make sure that the cables are routed correctly. Keep cables clear of the hinges
and sides of the computer chassis to avoid interference with closing the
computer cover.
Figure 21. Cable routing
4. Close the computer cover as shown.
5. If there is an integrated cable lock available, lock the computer.
6. Reconnect the external cables and power cords to the computer. See "Locating
connectors on the rear of your computer" on page 8.
7. To update your configuration, see Chapter 4, "Using the Setup Utility," on page
41.
Note: In most areas of the world, Lenovo requires the return of the defective
Customer Replaceable Unit (CRU). Information about this will come with
the CRU or will come a few days after the CRU arrives.
Obtaining device drivers
You can obtain device drivers for operating systems that are not preinstalled at
http://www.lenovo.com/support. Installation instructions are provided in readme
files with the device-driver files.
Chapter 2. Installing or replacing hardware
29