Change Wan Mtu Via Web-Gui - ZyXEL Communications P-660HN-T1A Support Notes

mask]
sys filter set destport [port#] [compare
type = none|equal|notequal|less|greater]
sys filter set srcip [address] [subnet
mask]
sys filter set srcport [port#] [compare
type = none|equal|not
equal|less|greater]
sys filter set tcpEstab [yes|no]
sys filter set more [yes|no]
sys filter set log [type 0-3= none | match|
notmatch | both ]
sys filter set actmatch[type 0-2 =
checknext | forward | drop]
sys filter set actnomatch [type 0-2 =
checknext | forward | drop]
sys filter set offset [#]
sys filter set length [#]
sys filter set mask [#]
sys filter set value [(depend on length in
hex)]
sys filter set clear
sys filter set save
sys filter set display [set#][rule#]
sys filter set freememory

16. Change WAN MTU via WEB-GUI.

You can change WAN MTU by: Network > WAN > Internet Connection >
Advanced Setup, the default value is 1500.
All contents copyright © 2010 ZyXEL Communications Corporation.
P-660HN Series Support Notes
the rule
Set the destination port and compare type (compare
type could be 0(none)|1(equal)|2(not
equal)|3(less)|4(greater) )
Set the source IP address and subnet mask
Set the source port and compare type (compare
type could be 0(none)|1(equal)|2(not
equal)|3(less)|4(greater) )
Set TCP establish option
Set the more option to yes/no
Set the log type (it could be 0-3 =none, match, not
match, both)
Set the action for match
Set the action for not match
Set offset for the generic rule
Set the length for generic rule
Set the mask for generic rule
Set the value for generic rule
Clear the current filter set
Save the filter set parameters
Display Filter set information. W/o parameter, it will
display buffer information.
Discard Changes
84