Initial Setup - Fujitsu ETERNUS DX80 S2 Manual

ETERNUS Web GUI Startup
1.
Open the Web browser on the PC terminal.
2.
Enter either of the following URLs in the address bar
of the Web browser.
http://192.168.1.1/
The login screen for ETERNUS Web GUI appears.
3.
To change the user interface language, click the
[Option] button and select "English" or "Japanese" in
"Language".
4.
Enter the Username and Password.
User name: root
Password: root (by default)
After logging in, the Initial Settings screen of ETERNUS
Web GUI appears.
-Installation- "5.1.3 ETERNUS Web GUI Startup"

Initial Setup

Perform the settings that are required before operation of the ETERNUS DX Disk storage system on the initial setup
screen.
Perform the following settings according to the wizard
screen:
Set Storage Name
●
Set Date and Time
●
Change Password
●
Register Thin Provisioning License
●
Register Copy License
●
Register SED Authentication Key
●
Set Network Environment
●
After the settings are complete, close the Web browser and then remove the LAN cable (for operation management)
from the PC terminal. Connect LAN cables (for operation management) to the customer network from the MNT ports
on both controller 0 and controller 1.
Then start the web browser from the PC terminal that is connected to the network and log in to ETERNUS Web GUI
again with the IP address that is set in "Set Network Environment". After login, the Overview screen appears.
-Installation- "5.1.4 Initial Setup"
ETERNUS DX80 S2/DX90 S2 Disk storage system Read Me First
13
Copyright 2013 FUJITSU LIMITED
P3AM-4872-11EN