Temporary Tone - Qwest 2.4GHz Multi-Handset Cordless Phone System Owner's Manual

2.4GHz Multi-Handset Cordless Phone System
3. Press until a check mark appears next to "Monitor Room."
OK
4. Select "Set Call Number" and press OK.
5. Enter the handset number of the handset that will be alerted by this room
monitor handset. The handset number of the alerted handset must be different
than this room monitor handset. Enter 0 to alert the base speakerphone. Enter *
to alert all handsets and the base speakerphone.
6. Press OK.
7. Select "Set Level," press OK. There are three noise levels that will trigger a call.
To set the level on the room monitor, use the [3] and [4] arrow keys. The Level
1 setting requires the least amount of noise to trigger a call, Level 3 requires the
most amount.
8. Press then End.
OK
Note: The handset remains in the Room Monitor mode until you disable it.
To disable the Room Monitor,
1. Select "Room Monitor;" press OK.
2. Press OK to remove checkmark and then End to return handset to idle state.
Note: An incoming call will not ring on handsets in the Room Monitor mode. You
will see the call on the handset's display, and you may pickup the call by pressing
Talk.

Temporary Tone

The system is set to tone dialing from the factory. If your phone line is set to pulse
dialing, you can access bank facilities and telephone answering machines through
the handset's temporary DTMF menu.
1. Press Talk.
2. Press Menu.
3. Scroll to the Temp DTMF On/Off toggle key.
4. Press OK.
5. Dial number. The handset will reset automatically when the call ends.
To set your phone to pulse dialing
1. Press Menu.
2. Select "System Settings", press OK.
3. Select "Tone/Pulse Dial", press OK.
4. Select "Pulse Dialing". A check mark appears next to Pulse Dialing.
Page 19