Jumpers - Foxconn P35A Series User Manual

section of the BIOS Setup. These fans will be automatically turned off after the system enters S3,
S4 and S5 mode.
GND
1
+12V
SENSE
FAN1/2/3

2-5 Jumpers

For some features needed, users can change the jumper settings on this motherboard to modify
them. This section explains how to use the various functions of this motherboard by changing the
jumper settings. Users should read the following content carefully prior to modifying any jumper
setting.
Description of Jumpers
1. For any jumper on this motherboard, pin 1 can be identified by the bold silkscreen next to it.
However, in this manual, pin 1 is simply labeled as "1".
2. The following table explains different types of the jumper settings. "Closed" means placing
a jumper cap on the two pins to temporarily short them. The shorting can also be done by
touching two pins by a screwdriver for a few seconds, but using jumper cap is recommended.
It can prevent any ESD (Electrical Static Discharge) problem.
Jumper
1
1
bIoS Tbl enable Jumper: Tbl_eN
Occasionally, user may go to website to look for newly updated BIOS information, and when in
upgrading the BIOS, if the power happened to be shut down, or any abnormal operation during
Diagram Definition
1-2
1
2-3
1
Closed
1
Opened
1
18
CPU_FAN / SYS_FAN
Description
Set Pin 1 and Pin 2 closed
Set Pin 2 and Pin 3 closed
Set two pins closed
Set two pins opened
1
GND
POWER
SENSE
CONTROL