Foxconn P35A Series User Manual page 112

2. Copy section 5-2, BIOS Configuration.
Shut down the computer, connect SATA hard disks to SATA ports, power on
computer again.
Press <Del> key, get into BIOS, set SATA mode to [RAID], press <F10> to save and
exit BIOS. PC will reboot.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
IDE Configuration
SATA Mode Select
Max Ports on SATA
► AHCI Configuration
► Primary IDE Master
► Primary IDE Slave
► Secondary IDE Master
► Secondary IDE Slave
IDE Detect Time Out (Sec)
↑↓←→:Move Enter:Select
F7:Previous Values
3. Copy section 5-3, Create RAID in BIOS.
Press <CTRL><I> simultaneously to get into RAID BIOS set up (Intel
Storage Manager option ROM utility).
Configure your new hard disks to RAID0, 1, 5 or 10. Exit RAID BIOS. PC will reboot.
4. The Windows XP is running again and a new hardware of RAID disk was found.
Click [Cancel] to skip this Wizard.
IDE Configuration
[RAID] [RAID] Select SATA Work Mode
[6 Ports]
[Press Enter]
Intel Matrix Storage
[Not Detected] Manager driver only
[Not Detected] support on
[Not Detected] ICH9R( P35A-S ),
[Not Detected] not ICH9. ( P35A )
So if your MB is with
[35] ICH9 chip, then you
can't enable AHCI in
Windows XP,
Windows Vista
has in-box driver.
So it's ok.
+/-/:Value F10:Save ESC:Exit
F8:Fail-Safe Defaults
105
Help Item
F1:General Help
F9:Optimized Defaults
®
Matrix
Click to exit.