Installing Sfp And Sfp+ Modules - Cisco 2960-S Hardware Installation Manual

Installing SFP and SFP+ Modules

Figure 2-21
1
Secure the AC power cord by pressing on the retainer. See
Step 6
Figure 2-22

Installing SFP and SFP+ Modules

Some switch models support SFP modules, SFP+ modules, or both. The SFP slots support only the SFP
modules. The slots marked SFP+ slots support both SFP and SFP+ modules.
See the
for the list of supported SFP modules. Use only Cisco SFP modules on the switch. Each Cisco module
has an internal serial EEPROM that is encoded with security information. This encoding provides a way
for Cisco to identify and validate that the module meets the requirements for the switch.
For information about installing, removing, cabling, and troubleshooting SFP modules, see the module
documentation that shipped with your device. For module cable specifications, see
"Connector and Cable Specifications."
Catalyst 2960-S Switch Hardware Installation Guide
2-20
Sleeve Around the Power Cord
1
Sleeve for thin power cords
Securing the Power Cord in the Retainer
"SFP and SFP+ Module Slots" section on page 1-8
Chapter 2
1
2 AC power cord
Figure 2-22.
and the switch release notes on Cisco.com
Switch Installation
2
Appendix B,
OL-19732-04