Specifications - Celestron 44330 Instruction Manual

Standard Accessories with your Microscope
20x Eyepiece
5x Objective Lens
10x Objective Lens
20x Objective Lens
Bottom Illuminator
Model # 44330
Stage
Eyepiece
Focuser
Objective Lenses
USB Cable
Illuminator -- Bottom
Nosepiece
Digital Camera
Weight (with batteries)
and Dimensions
1. Carefully remove the microscope and other parts from
the box and set them on a table, desk, or other flat
surface.
2. Remove the plastic bag covering the microscope.
3. Remove the plastic plug up cap from the eyepiece tube
and install the eyepiece – see Figure 1.
4. Install the batteries for the bottom illuminator in the
base of the microscope which uses two AAA batteries
(user supplied). See Figure 2 showing the open battery
compartment under (bottom) microscope. Install the
batteries (see the inside of the battery compartment where the positive (+)
and negative (-) ends of the batteries go).
You are now ready to use your microscope for looking at specimen slides or
small objects through the microscope eyepiece as an optical microscope! For
using the digital (CMOS) camera, installation and operating instructions will
follow later in this manual.

Specifications

Plain Stage with Spring Loaded Clips – 80 mm x 60 mm (3.1" x 2.4")
Glass Optics
Coarse Focus – Dual Knobs
All Glass Optics – 5x (100 power), 10x (200 power), 20x (400 power)
2.0
LED -- Uses 2AAA Batteries (user supplied)
Triple with Click Stop
2MP CMOS – 1600x1200 pixel array
19oz (539g) 4.5" x 4" x 6" (114 mm x 102 mm x 152 mm)
Setting Up Your Microscope
Digital Camera w/ USB Cable
3 Prepared Slides
CD-ROM – ArcSoft Software
Instruction Manual
Specifications
3
Figure 2