Fox Intelligent Stepping - Foxconn A79A-S User Manual

► Smart Power LED
Smart Power LED is a feature built on your motherboard to indicate different states during
Power On System Test (POST). The LED is located at the front panel, and it displays POST
state by different long-short blinking intervals. You can always leave this state enabled.
Please refer to the following table.
System Status
Normal
No Memory
No Display
Post Error Message
No CPU Fan
► Smart Boot Menu
This item is used to enable or disable the smart boot menu. select [F11] will provide a timer
to let user to control boot device easily.
► Current CPU Speed
This item displays the current CPU speed.
► Current FSB/HTT Speed
This item displays the current Front Side Bus speed.
► Current CPU Multiplier
This item displays the current CPU Ratio.
► Current Memory Speed
This item displays the current memory speed.

Fox Intelligent Stepping

CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
CPU/HT Reference Clock (MHz)
PCIE Reference Clock (MHz)
SB Reference Clock (MHz)
Processor Frequency (FID)
Spread Spectrum
► AM2+ CPU Ratio Adjust
CPU-NB HT Link Speed
NCHT Incoming Link Width
NCHT Outgoing Link Width
↑↓←→:Move Enter:Select
► CPU/HT Reference Clock (MHz)
This option is used to adjust the CPU clock.
► PCIE Reference Clock (MHz)
This option is used to adjust the speed of PCI Express slot. It may enhance the graphics card
speed.
Power LED Status
Always On
Continue blinking On (1sec.), Off (1sec.)
Continue blinking On (2sec.), Off (2sec.)
Quick blinking twice (1/3sec. On, 1/3sec. Off),
one long On (1sec.), continuously.
Continue blinking On (1/2sec.), Off (1/2sec.)
Fox Intelligent Stepping
[200]
200
[100]
[100]
[Auto]
[Disabled]
[Press Enter]
[Auto]
[Auto]
[Auto]
+/-/:Value F10:Save
F9:Optimized Defaults
27
Stop Blinking Condition
Always On
Reboot & Memory OK
Reboot & Display OK
Enter Setup or Skip
Reboot & Fan OK
Help Item
ESC:Exit F1:General Help