Setting Up A Non-Bootable Raid Array - Foxconn A88GM Deluxe User Manual

5-5 Setting Up a Non-Bootable RAID Array

This section assumes the following setup :
■ Boot Disk with Windows XP installed :
One hard disk HDS728090PLAT20 (80GB) is connected to the IDE channel, and set
to Master.
■ A Mirrored RAID Array Disk :
Two SATA hard disks are configured as a mirrored RAID1 array, they are :
Hitachi HDT725025VLA3, (250.05GB) connected to SATA port2 of the motherboard.
Seagate ST3320620AS, (320.07GB) connected to SATA port3.
■ A SATA DVD Drive :
A DVD drive connected to SATA port1.
To achieve the best performance and reliability, we highly recommend you
using the hard disks with the same brand, size and model number. Though
we are using different brand of hard disks as an example here, the purpose
is only for easy understanding.
1. Reboot your system, and go to "IDE Configuration" menu.
Enable the RAID function. Press [F10] to save the settings and reboot.
CMOS Setup Utility - Copyright (C) 1985-2006, American Megatrends, Inc.
IDE Configuration
OnChip SATA Channel
OnChip SATA Type
OnChip IDE Type
SATA IDE Combined Mode
↑↓←→:Move Enter:Select
IDE Configuration
[Enabled]
I
[RAID]
[Legacy IDE] Native IDE
[Disabled] RAID
AHCI
Legacy IDE
+/-/:Value F10:Save ESC:Exit
F9:Optimized Defaults
99
Help Item
Options
F1:General Help