C Ommands - GE MultiLink ML1600 Instruction Manual

IMPORTANCE OF AN IP ADDRESS
Note
5–6
Inbound Telnet Enabled: Yes
Outbound Telnet Enabled: Yes
Web Console Enabled: Yes
SNMP Enabled: Yes
Terminal Type: VT100
Screen Refresh Interval (sec): 3
Baud Rate: 38400
Flow Control: None
Session Inactivity Time (min): 10
ML1600#
Users can telnet to a remote host from the MultiLink family of switches using the following
syntax.
telnet <ipaddress> [port=<port number>]
The default port for telnet is 23.
The ML1600 will time out an idle telnet session. It may be useful to see who is currently
connected to the switch. It may also be useful for a person to remotely terminate a telnet
session. To facilitate this, the ML1600 supports the following two commands:
show session
kill session id=<session>
For example:
user
ML1600#
useraccess user=peter service=telnet enable
ML1600(user)##
Telnet Access Enabled.
exit
ML1600(user)##
show session
ML1600#
Current Sessions:
SL# Sessn Id Connection
1 1 163.10.10.14
2 2 163.11.11.1
3 3 163.12.12.16
kill session id=3
ML1600#
Session Terminated
ML1600#
In the above example, the user with username "peter" is given telnet access. Then multiple
users telnet into the switch. This is shown using the
operator session is then terminated using the
A maximum of four simultaneous telnet sessions are allowed at any time on the switch.
The commands in these telnet windows are executed in a round robin fashion; that is, if
one window takes a long time to finish a command, the other windows may encounter a
delay before the command is completed. For example, if one window is executing a file
download, the other windows will not be able to execute the command before the file
transfer is completed. As well, if a outbound telnet session is started from the switch
(through a telnet window) then other windows will not be able to execute a command until
the telnet session is completed.
MULTILINK ML1600 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
User Name User Mode
manager Manager
peter Manager
operator Operator
show session
kill session
CHAPTER 5: IP ADDRESSING
command. The user
command.