GE MultiLink ML1600 Instruction Manual page 170

CONFIGURING TAG VLANS THROUGH THE COMMAND LINE INTERFACE
Converting Port VLAN to Tag VLAN (continued)
ML1600(tag-vlan)##
set-port port=14-16 filter status=enable
WARNING: PVID does not match the port(15)'s VLAN ID(s).
If you are using telnet session on this port,setting ingress might stop the session.
Do you want to continue? ['Y' or 'N'] Y
WARNING: PVID does not match the port(14)'s VLAN ID(s).
If you are using telnet session on this port, setting ingress might stop the session.
Do you want to continue? ['Y' or 'N'] Y
WARNING: PVID does not match the port(16)'s VLAN ID(s).
If you are using telnet session on this port, setting ingress might stop the session.
Do you want to continue? ['Y' or 'N'] Y
Ingress Filter Enabled
ML1600(tag-vlan)##
show vlan type=tag
VLAN ID : 1
Name : Default VLAN
Status : Active
==============================
PORT | MODE
==============================
9 | UNTAGGED
10 | UNTAGGED
11 | UNTAGGED
12 | UNTAGGED
13 | UNTAGGED
VLAN ID : 10
Name : engineering
Status : Active
==============================
PORT | MODE
==============================
14 | UNTAGGED
15 | UNTAGGED
16 | UNTAGGED
VLAN ID : 20
Name : sales
Status : Active
==============================
PORT | MODE
==============================
14 | UNTAGGED
15 | UNTAGGED
16 | UNTAGGED
VLAN ID : 30
Name : marketing
Status : Active
==============================
PORT | MODE
==============================
14 | UNTAGGED
15 | UNTAGGED
16 | UNTAGGED
(continued on next page)
10–18
| STATUS
| UP
| DOWN
| DOWN
| DOWN
| UP
| STATUS
| DOWN
| DOWN
| DOWN
| STATUS
| DOWN
| DOWN
| DOWN
| STATUS
| DOWN
| DOWN
| DOWN
MULTILINK ML1600 ETHERNET COMMUNICATIONS SWITCH – INSTRUCTION MANUAL
CHAPTER 10: VLAN
Enable filtering on the ports required. The
software will prompt to ensure that
connectivity is not disrupted.
VLANs are now active. However, as the
packet traverses VLANs, the packet should
be tagged. This is enabled next.